Other Specialty Testing

Project Overview

Pie’s ability to provide solutions for our clients unique project needs goes beyond design and construction phase services. In addition to our regularly performed field testing services, Pie staff is equally experienced in providing specialty field testing services including Relative Humidity Testing per ASTM F 2170 (pictured above). Pie has a large inventory of equipment to facilitate a variety of tests, and can easily navigate the catalog of ASTM standards to determine a test method to meet project needs for quality assurance verification. The following represents the complete list of field testing capabilities Pie can provide:

ASTM E1105
Water Penetration of Installed Exterior Windows, Skylights, Doors and Curtain Walls by Uniform or Cyclic Air Pressure Difference

Air Leakage Through Installed Exterior Windows and Doors (and opaque walls)

AAMA 501.2
Water Leakage Field Check of Installed Storefronts, Curtain Walls, and Sloped Glazing Systems

Adhesion-in-Peel of Elastomeric Joint Sealants

ASTM C1193
Guide for Use of Joint Sealants:  Field Applied Sealant Joint Hand Pull Tab

ASTM C1715
Water Leakage Performance of Masonry Wall Drainage Systems

ASTM D4541
Pull-Off Strength of Coatings Using Portable Adhesion Testers

ASTM D7234
Pull-Off Adhesion Strength of Coatings on Concrete

Determining Air Leakage Rate by Fan Pressurization

ASTM E1827
Determining Airtightness of Buildings Using an Orifice Blower Door

ASTM C1060
Thermographic Inspection of Insulation in Envelope Cavities of Frame Buildings

ASTM E1186
Air Leakage Site Detection in Building Envelope and Air Barrier Systems

ASTM C1153
Location of Wet Insulation in Roofing Systems Using Infrared Imaging

ASTM E907/FM 1-52
Field Testing Resistance of Adhered Membrane Roofing Systems

ASTM D5957
Flood Testing Horizontal Waterproofing Installations

Electronic Leak Detection Testing for Roofing and Waterproofing Membranes

Strength of Anchors in Concrete and Masonry Elements

ASTM E2359
Field Pull Testing of an In-Place Exterior Insulation and Finish System Clad Wall Assemblies

ASTM F1869
Measuring Moisture Vapor Emission Rate of Concrete Subfloor Using Anhydrous Calcium Chloride

ASTM F2170
Determining Relative Humidity in Concrete Floor Slabs Using in-situ Probes

NFPA 2001
Standard on Clean Agent Fire Extinguishing Systems

Horizontal Pull Slipmeter Testing

Related Projects


Performance Testing & Monitoring

All Markets

Nationwide & Internationally